Did some fittings and knots this morning and had our quiz at 1pm

Brought up my mark a bit I hope study hard here on out5

Started Tube bending project today

I first made a sketch of my tube bending project made my demensions 28" length and 28" width. Secondly I figured how much Copper fittings and made a meterials list , made my 60° degrees 45° degrees 22 1/2" °with protractor found travel for 22 1/2" which was 7 15/16" ,

manual

starting oxy acytelene

Almost complete 4" cast iron and 3" and 2" project

Just need to make a materials list I'll be done

Started cast iron project DWV 4" , 3", 2",

4" pipe has 1/8" per ft slope . 3" pipe has 1/4" per ft slope same with the 2" cast iron pipe. Found where the clean outs are the water  loser and also the lavatory. 

Glen bought us new fittings

Brushed up on some rigging this morning & made a rough copy of cast iron project

Started rigging today just the basics

Watched a few demo of oxy acetylene torch cutting

Pressure tested stayinf

Completed just going to cut

Ridged tools

Ridged guy came out this morning schooled us on the power 300 threader and a few new gadgets

Changed dies also

Started temperature and heat assignment also perimeters, Areas, Volumes, Capacities, Percantage and grade

Started and completed unit 32 Grade, percent grade, drop, and run completed unit 33 elevation and grade

Brazed up my 3/4" copper project gonna air test it in morning

Practice up on brazing

My brazing project rough draft

Brazing complete

Iso and plan view included

3/4" copper M Brazing project completed

I measured all my lenths perfect